Thursday, July 28, 2011

ADK / Ethernet Shield Problem Solved!

Fixed! A quick trip to Radio Shack for some hookup wire (22 gauge, solid) and I manually wired the ICSP pins from the Ethernet Shield and now I have a web server that's just a bit bigger than a deck of cards.



Here is the ISCP pin mapping to the ADK pins for future reference:


(MISO)  50 <--  1 o  o 2 --> +5V
(SOCK)  52 <--  3 o  o 4 --> 51 (MOSI)
RESET      <--  5 o  o 6 --> GND


Only pins 1,3 and 5 need to be connected (orange wires in the picture). The Ethernet shield still works if you leave pins 2, 5 and 6 disconnected (red, yellow and green wires in picture).
Posted by +Joe Fernandez at 11:00 PM
Labels: , , ,

1 comment:

  1. mike L.December 18, 2011 at 3:18 PM

    I have done this, but I cannot upload sketches to the ADK with the ethernet shield connected. With pins 1, 3 and 4 connected the ethernet shield works as expected. Does pin 5, reset need to be connected?

    Currently I have to remove the shield to upload new sketches to it. Any ideas?

    ReplyDelete

Subscribe to: Post Comments (Atom)